How to Fix a Dead Kia Picanto Key Fob
The Kia Picanto is a city car that can swerve through traffic gaps and width restrictions as if they weren't there. It's a compact car with lots of features.
There are a myriad of reasons your Kia Picanto key fob may not be working. A dead battery is the most common cause.
Dead Coin Battery
The most frequent reason why a Kia Picanto key fob stops functioning is due to a dead battery. Usually, the key fob will show warning signs prior to it dying and loses the range or showing irregular behavior. If kia car key cover G28CarKeys notice any of these warning indicators, it's best to replace the battery before it has completely failed. Use a battery that has the same voltage, size and specifications as the original.
If the key fob still does not work, it might be the right time to go to a dealer for a new one. This is the only way to guarantee the replacement will be correctly programmed and compatible with your vehicle. If you attempt to reprogram keys without following the correct procedure could damage the chip's internal circuit and result in it not functioning.
A receiver module that has acquired a fault is another possibility. This could be due to a chip that has been damaged or simply wear and tear as time passes. Symptoms of this problem can be difficult to recognize but it is essential to investigate the issue whenever you can. If your key fob isn't functioning, or if the spare doesn't function then you should call an auto dealer for assistance. They will be able diagnose the problem and fix it for you.
Faulty Chip
The key fob comes with an internal chip that transmits an information signal to the car's computer. If the chip is damaged, the code will not be transmitted correctly and the immobilizer will be activated. This can happen due numerous reasons. One of them is a low battery in the key fob. Water damage is another possibility. It is possible that the fob will stop working if it gets wet.
A defective chip could be the cause for the Picanto key fob that isn't turning on the engine. If you've replaced batteries, reprogrammed or reprogrammed the fob but it still doesn't work, the circuit board could be damaged. You will need to replace the circuit board If this is the case.
Press the button on the back to unlock the fob. Once this is done you will be able to take off the mechanical key. Then, follow the steps below to replace the battery on the key fob. Make sure you use a battery that has the same dimensions and voltage. The Fob could be damaged if you use the wrong type battery. After replacing the battery you should check it by pressing the lock button. If it works, then you have a working Fob.
Faulty Receiver Module
Your key fob is not impervious to damage and can take a lot of abuse. Over time, the battery contacts and buttons of your key fob might be damaged. It's simple to repair it by using a few simple tools.
To function, the fob needs to transmit a signal to the receiver inside your car. If the module is not functioning properly the fob won't in a position to open or start the vehicle. There are many possible causes for this issue however the first thing to do is reset the fob.
This is typically done by disconnecting the battery with 12 volts in the fob and allowing it to drain completely. Then, reconnecting the negative and positive cables in reverse order.
If the battery is good and the fob has no water damage, it could simply be experiencing problems with its signal. This could be due to many things including interference from nearby transmitters or objects that operate on the same frequency band as the Picanto's receiver.
Key fobs are made with rubber seals to keep the chip inside from getting wet. However, when they are submerged in water for extended periods of time they could be destroyed. It's crucial to keep your key fob out of water and only use key fobs with waterproof designs.
Incorrect programming
Kia Picanto's keys make it easy to unlock and start your vehicle. You can also make use of the key fob to control your vehicle. It is important to know how to use the key fob properly especially in harsh weather conditions or if you are unable to move. There are many Kia Picanto keys tricks that can aid you.
If your key fob stopped functioning suddenly It could be because of a problem with its internal chip. It is not a common occurrence however it could happen. It is best to visit an Kia dealer to pinpoint the issue.
You can also reset the Picanto keyfob. It's a simple process and can be carried out at home. The first step is to remove the key fob from the ignition switch. Connect the diagnostic tool under the dashboard to the OBDII connector and start the engine. The diagnostic tool will be asking you for information about the Picanto. This includes the manufacturer and model as well as the VIN.
You can also test the battery for a dead coin battery. The metal retaining clips that are inside the key fob are designed to keep the battery in place and complete the circuit. If the retaining clips are loose it could interrupt the flow of electric current, resulting in the key fob to cease functioning.